GPIO Out (QIO-GP8x8, QIO-FLEX4A )
Some Q-SYS QIO devices have General Purpose Output pins for extension of Q-SYS Control to third-party devices. In the Q-SYS Designer Software component properties, you can configure the output signal type for each pin – digital, open collector, or raw.
To see GPIO interface information, Example Applications, and Behavior During Boot-up and Redeploy for your device, visit General Purpose Input Output (GPIO) Application.
Properties
Tip: For additional properties that are not listed, refer to the Properties Panel help topic for more information.
GPIO-1 to 8
Type
Select the type of GPIO output:
- Digital Output (TTL 3.3V): 3.3VDC is supplied to the GPIO output pin when the Output control is enabled.
- Open Collector (200mA): 24V, 200mA max with pull-up to +3.3V.
- Raw: This mode is for advanced capabilities. If there is something you cannot do using the other choices, contact Q-SYS Support for assistance.
Controls
Output
This button sends a 0 in the Off position and a 1 (3.3V TTL) in the On position.
Invert
This button is available when the Type is Raw.
Control Pins
|
Pin Name |
Value |
String |
Position |
Pins Available |
|---|---|---|---|---|
|
Output (Digital Output, Open Collector, Raw) |
0 1 |
false true |
0 1 |
Input |
|
Invert1 |
0 1 |
false true |
0 1 |
Input / Output |
1. Available in the Control Pins list when Type is set to Raw. |
||||
