The POTS In component receives the incoming audio from a telephone call, converts the analog signal to digital, and monitors and modifies the audio using the controls listed below.
Control |
Function |
Default / Range |
---|---|---|
Peak Input Level (dBFS) |
Measures the analog input signal. |
Green = good Yellow = close to clipping Red = clipping |
Clip |
Red LED indicating if the signal is being clipped. |
Off / On |
Clip Hold |
Holds the clip indication until manually cleared by pressing this button to the Off position. |
Off / On |
Control |
Function |
Default / Range |
---|---|---|
Invert |
Toggle button to invert the digital output of the POTS In. |
Off / On |
Mute |
Mutes the output signal. |
Off / On |
Gain (dB) |
Controls the Gain of the digital output signal. |
Default = 0 Range = -100 to 20 |
Control |
Function |
Default / Range |
---|---|---|
Status LED |
This LED changes color to indicate the current status of the Core. See Status for the meanings of the various colors. |
N / A |
Status |
Displays color-coded messages indicating the current status of the active Core. Note: These conditions are examples, and may not be applicable to all components with a Status field. OK – Green – (0) – Audio is good, hardware is good. Compromised – Orange – (1) – Audio is good but a redundancy mechanism is active (one LAN down but the other is still up) or a non-fatal hardware problem exists (fans too slow, temperature higher than expected, etc.) Fault – Red – (2) – Audio is not passing, or hardware is malfunctioning or mis-configured (amplifier power off, audio streams broken, wrong type of I/O Card installed, loudspeaker short circuit, etc.) Missing – Red – (3) – A piece of hardware, defined in the design, has not been discovered. Audio is not passing through that piece of hardware. Initializing – Blue – (5) – In the process of firmware, configuration update, and design start. Audio is obviously bad. Not Present – Gray – A virtual component in the design, that is designated as Dynamically Paired, and Not Required ,has no hardware assigned to it. |
N / A |
There are no configurable properties for this component.
Pin Name |
Value |
String |
Position |
Pins Available |
---|---|---|---|---|
Channel n Clip |
0 1 |
false true |
0 1 |
Output |
Channel n Clip Hold |
0 1 |
false true |
0 1 |
Input / Output |
Channel n Digital Level |
-100 to 20 |
-100 dB to 20 dB |
0.000 to 1.00 |
Output |
Channel n Gain |
-100 to 20 |
-100 dB to 20 dB |
0.000 to 1.00 |
Input / Output |
Channel n Invert |
0 1 |
normal invert |
0 1 |
Input / Output |
Channel n Mute |
0 1 |
unmute mute |
0 1 |
Input / Output |
Status |
Text |
Output |
Software and Firmware | Resources | QSC Self Help Portal | Q-SYS Help Feedback
Copyright © 2019 QSC, LLC. Click here for trademark and other legal notices. |