The POTS Out component converts the processed digital signal to analog and provides software controls before and after the convertor. The output is sent to the POTS telephone system servicing the call.
Control |
Function |
Default / Range |
---|---|---|
Peak Line Level (dBm @600Ω) |
Measures Peak Output level to the RJ11 output. |
N / A |
Control |
Function |
Default / Range |
---|---|---|
Peak Output Level (dBFS) |
Measures the Digital Signal level prior to the D/A converter. |
Green = good Yellow = close to clipping Red = clipping |
Clip |
Red LED indicating if the signal is being clipped. |
Off / On |
Clip Hold |
Holds the clip indication until manually cleared. |
Off / On |
Invert |
Inverts the audio signal. |
Off / On |
Mute |
Mutes the digital audio signal. Note: Note: Dialing is enabled regardless of the Mute state. |
Off / On |
Gain |
Controls the gain of the digital audio signal prior to the D/A converter. |
Default = 0 Range = -100 to +20 |
Control |
Function |
Default / Range |
---|---|---|
Status |
Displays the current status of the amplifier both in text and color. The following is a list of possible status colors, and some example conditions. Note: These conditions are examples, and may not be applicable to all components with a Status field. OK – Green – (0) – Audio is good, hardware is good. Compromised – Orange – (1) – Audio is good but a redundancy mechanism is active (one LAN down but the other is still up) or a non-fatal hardware problem exists (fans too slow, temperature higher than expected, etc.) Fault – Red – (2) – Audio is not passing, or hardware is malfunctioning or mis-configured (amplifier power off, audio streams broken, wrong type of I/O Card installed, loudspeaker short circuit, etc.) Missing – Red – (3) – A piece of hardware, defined in the design, has not been discovered. Audio is not passing through that piece of hardware. Initializing – Blue – (5) – In the process of firmware, configuration update, and design start. Audio is obviously bad. Not Present – Gray – A virtual component in the design, that is designated as Dynamically Paired, and Not Required ,has no hardware assigned to it. |
N / A |
There are no configurable properties for this component.
Pin Name |
Value |
String |
Position |
Pins Available |
---|---|---|---|---|
Channel n Clip |
0 1 |
false true |
0 1 |
Output |
Channel n Clip Hold |
0 1 |
false true |
0 1 |
Input / Output |
Channel n Digital Level |
-100 to 20 |
-100 dB to 20 dB |
0.000 to 1.00 |
Output |
Channel n Gain |
-100 to 20 |
-100 dB to 20 dB |
0.000 to 1.00 |
Input / Output |
Channel n Invert |
0 1 |
normal invert |
0 1 |
Input / Output |
Channel n Mute |
0 1 |
false true |
0 1 |
Input / Output |
Channel n Peak Line Level (dBm @ 600Ω) |
-120 to 20 |
-120 dB to 20 dB |
0.000 to 1.00 |
Output |
Software and Firmware | Resources | QSC Self Help Portal | Q-SYS Help Feedback
Copyright © 2019 QSC, LLC. Click here for trademark and other legal notices. |