You are here:

Status

The Status page provides an overview of the health of the Q-SYS system, including a list of all devices in the running design and their statuses.

Core and System Details

Model: The Q-SYS Core processor model.
Redundancy: Indicates the status of the redundant Core configuration (if redundancy is enabled in the design).
Firmware Version: The Q-SYS firmware currently running on the Core.
Card Slots: For Q-SYS Core processor models supporting Q-SYS I/O cards, click View to see a list of installed card types.
System Name: Use this property to assign a friendly name for the location, area, etc. being managed by this Q-SYS Core processor – for example, "Conference Room 1". Click Rename System to assign a new name.
Design File: The design file currently running on the Core.
Last Update: A date stamp corresponding to the last time the design file starting running on the Core.

Inventory

The Inventory table lists all devices within the running design, and provides an at-a-glance view of their statuses, assigned names, types, Q-SYS model name, and location. Location information is determined from the Location component property in the design.

Status Reference

Unknown	This status appears during a Core reboot (for example, during a firmware update), or when a design is being pushed to the Core and before it has started running.
OK	The device is functioning normally.
Initializing	The device is in the process of a firmware or configuration update, or the design is starting. If available, click for more information.
Compromised	The device is functioning, but a non-fatal problem exists. Click for details about the problem.
Missing	The device cannot be discovered. Click for details about the problem.
Fault	The device is malfunctioning or is mis-configured. Click for details about the problem.
Not Present	This status appears when the device is not connected to the network and its Is Required component property is set to 'No'. This status also appears if the device component's Dynamically Paired property is set to 'Yes', pairing has not been assigned in Core Manager, and the device component's Is Required property is set to 'Yes'. For more information about dynamic pairing, see See Dynamic Pairing.

Software and Firmware | Resources | QSC Self Help Portal | Q-SYS Help Feedback