CTEL4 – Analog Telephony Card
The CTEL4 card provides four RJ-11 interfaces to connect the Q-SYS Core or I/O Frame to analog telephony (POTS) environments.
For configuration information, see POTS Controller, POTS In, and POTS Out.
Product Identification Numbers
US: 6M2BR01ACTEL4
IC: 20383-CTEL4
About Type 2 Hardware
The CTEL4 card is Type 2 hardware.
Type 2 hardware provides new cables and connectors between the I/O cards and main boards in Cores and I/O Frames. Due to this change, the Type 2 hardware is not physically compatible with the older hardware. You can still integrate the new I/O Frames and Cores in the same system with older hardware, but the I/O cards are not interchangeable. Type 2 hardware can be identified by a yellow label on the back of the Core and I/O Frame, and the bottom of the I/O cards.
Installation Limitations
Due to electrical current limitations imposed on telephony devices, there is a limit to the number of CTEL4 cards that can be installed in Q-SYS host hardware.
|
Host Hardware |
Available I/O Slots |
Max CTEL4 Cards Allowed |
|---|---|---|
|
Q-SYS Core 510 Series |
8 |
3 |
|
Q-SYS I/O Frame |
4 |
3 |
|
Q-SYS Core 3100, Core 1100 |
1 |
1 |
|
Q-SYS Core 500i |
8 |
1 |
|
Q-SYS Core 250i |
8 |
1 |
|
Q-SYS I/O Frame 8s |
8 |
1 |
Note: The CTEL4 card limits do not affect other Q-SYS I/O cards. All other Q-SYS I/O cards (in any combination) may be installed into a host product alongside the supported CTEL4 maximums.
Specifications
|
CTEL4 Card |
|
|---|---|
System Hardware |
CTEL4 | POTS Card for Q-SYS |
Description |
Four Line Analog Telephony Interface I/O Card |
Connectors |
Four RJ-11 |
