AVB Status Component

Status LED

This LED changes color to indicate the current status of the I/O-22 Output. See Status for the meanings of the various colors.

Status

Displays the current status of the amplifier both in text and color. The following is a list of possible status colors, and some example conditions.

NOTE:  These conditions are examples, and may not be applicable to all components with a Status field.

OK – Green – (0) – Audio is good, hardware is good.

Compromised – Orange – (1) – Audio is good but a redundancy mechanism is active (one LAN down but the other is still up) or a non-fatal hardware problem exists (fans too slow, temperature higher than expected, etc.)

Fault – Red – (2) – Audio is not passing, or hardware is malfunctioning or mis-configured (amplifier power off, audio streams broken, wrong type of I/O Card installed, loudspeaker short circuit, etc.)

Missing – Red – (3) – A piece of hardware, defined in the design, has not been discovered. Audio is not passing through that piece of hardware.

Initializing – Blue – (5) – In the process of firmware, configuration update, and design start. Audio is obviously bad.

Not Present – Gray – A virtual component in the design, that is designated as Dynamically Paired, and Not Required ,has no hardware assigned to it.

Link LED

Indicates if there is a working connection to an AVB unit.

Full Duplex LED

Indicates if the link is communicating in both directions.

Speed

Up to 100Mbps maximum.

MAC Address

MAC address of the AVB card. Automatically populated.

Clock Source

Read / Write. The source of the clock signal.

Internal: The clock comes from the AVB card. This is not the Q-SYS clock.

AVB Input Stream <n>: The clock is derived from the Input Stream.

AVB Clock Source

N / A

Text

N / A

Current MAC Address

N / A

Text

N / A

Primary Full Duplex LED

1

2

Present

Not Present

0

1

Primary Link LED

1

2

Present

Not Present

0

1

Primary Speed

0 - 100

<n> Mbps

0 - 1