External USB Audio Device In

The following Q-SYS devices can accept a USB connection to an external audio device:

• Core 110f
• Cinema Core 110c
• TSC-7t Touch Screen Controller (with a Micro USB cable/adapter)
• I/O-USB Bridge

For compatibility with Q-SYS, your external USB device must support the following specifications.

Input Devices

• Sampling rate: 48k or 16k, mono
• Resolution: 8-bit, 16-bit, 24-bit, 32-bit, float
• Format: Little-endian, signed or unsigned

Output Devices

• Sampling rate: 48k only, stereo
• Resolution: 8-bit, 16-bit, 24-bit, 32-bit, float
• Format: Little-endian, signed or unsigned

1. Connect an external USB audio device to a compatible Q-SYS Core or peripheral USB port. See Supported Q-SYS Hardware.

   Note: If you connect multiple USB devices, the External USB Audio components will only detect the last one connected.

2. From your Inventory list, select the Q-SYS Core or peripheral.
3. In the Properties window, set External USB Audio to 'Enabled'.
4. From your Inventory list, drag the External USB Audio Device In and External Audio Device Out components into your schematic.
5. To send monaural audio from your device microphone, connect the External USB Audio Device In mono output pin to the input pin of a downstream component.
6. To send stereo audio to your playback device, connect the External USB Audio Device Out stereo input pins to the output pins of an upstream component.
7. Press F5 to save your design to the Core and run it. (Or, press F6 to emulate your design.)
8. Double-click an External USB Audio Device component to open the component's control panel. See Controls.

There are no configurable properties for these components.

Audio Device

A read-only indicator that shows the name of the detected external USB device.

Peak Input Level (dBFS)

Meter displaying the detected peak level of the audio input or output.

Invert

Click to invert the polarity of the input or output audio signal.

Mute

Click to mute the input or output audio signal.

Gain (dB)

Click to adjust the gain on the input or output audio signal, from -40 dB to 0 dB.

Connected

LED indicates whether the USB device is connected.

Fault

LED indicates whether a problem has been detected with the audio stream. Faults are logged in the Q-SYS Core Manager Event Log.

Pin Name	Value	String	Position	Pins Available
Active Device	(text)			Output
Connected	0 1	false true	0 1	Output
Fault	0 1	false true	0 1	Output
Channel n
Gain	-40 to 0	-40dB to 0dB	0.000 to 1.00	Input / Output
Invert	0 1	normal inverted	0 1	Input / Output
Mute	0 1	unmuted muted	0 1	Output
Peak Input Level	-120 to 43	-120dB to 43dB	0.000 to 1.00	Output