Signal Probe Component
The Signal Probe is a tool you can attach to any audio output and measure the signal at that point using various other components such as a True Peak/RMS Meter, Responsalyzer, RTA - Band-Pass, and so on.
Controls
|
Control |
Function |
Default / Range |
|---|---|---|
|
Valid |
Indicates if the connector the Signal Probe is connected to has a valid signal present or not. |
Off / On |
|
Probe |
In the Signal Probe Control Panel, click the Probe one time, then move it to the connector where you want to connect it and click that connector. The Probe is attached to that connector. To remove or move it, simply click the Probe and click in a blank area of the Schematic, or in the Signal Probe Control Panel, or a different connector. |
N / A |
|
Mute |
Mutes the output signal of the Probe. |
Off / On |
|
Gain (dB) |
Sets the output Gain of the Probe. |
Default = 0 Range = -100 to 20 |
Properties
There are no Properties for the Signal Probe.
Control Pins
|
Pin Name |
Value |
String |
Position |
Pins Available |
|---|---|---|---|---|
|
Gain |
-100 to 20 |
-100 dB to 20 dB |
0.000 to 1.00 |
Input / Output |
|
Mute |
0 1 |
unmute mute |
0 1 |
Input / Output |
|
Valid |
0 1 |
unmute mute |
0 1 |
Output |
